It is multi-system welding unit having the three most common welding methods in the same package. It is based on the most up-to-date technology in the welding field. Many different auxiliary functions simplyfy the work of the welder and increase the productivity of his work. It is most suitable where a job demands a continuous change of welding method. The following different facilities are provided in one package

A coolant pump fitted on a tank,
Diamond Dresser 2 nos.,
Oil can, Dead Center 2 nos.
Tool kit.

Additional attachment extra cost

Internal Grinding Attachment,
Balancing Stand,
Balancing Mandrel,
Three Points Steady Rest,
Two points Steady Rest,
Radius Truing Device,
Spare wheel Flange,
Independent Four Jaws Chuck,
Magnetic Coolant Pump,
Grinding Gauge.

Co2 Regulator cum Flow Meter
Helmet with glass
Pair of hand Gloves
Wire Brush
Apron & Spray

POWER SOURCE	MODEL	INV-500
Static Characteristics	Type	Constant Potential
Input Supply
Voltage	V	380-415
Phase	Nos.	3
Frequency	Hz	50-60
Welding Current Range	A/V	10/10 – 500/40
Rating 100% Duty Cycle	KVA	22
Open Circuit Voltage	V	80
Maximum Input Current	Amps	28
Load Ability @ 100%	Amps	390
Load Ability @ 60%	Amps	500
Cooling Type	Forced Air Cooling
Insulation	Class	F

WIRE FEEDER	MODEL	FEEDINV-500
Wire Diameter
Wire Drive Motor	Type	Permanent Magnet DC MOTOR
Drive System	Type	2 – Roll Quick Release
Wire Feed Speed	m/min	0 to 20

TORCH	MODEL	KD-36
Rated current at 100% Duty Cycle Co 2	Amps	400
Cable Hose Length	Mtr.	3
Cooling	Type	Gas/Water

POWER SOURCE	L	W	H
INVERTOR	760 mm	465 mm	610 mm
WIRE FEEDER UNIT	535 mm	235 mm	330 mm

Inverters